Watch your PulseLink camera from any phone or PC — and adjust it remotely.
Connect your watch
Open PulseLink on your watch and open the You menu. The bottom line is Device ID — enter the code shown there.
Camera
—
The picture is square but the camera sees wider, so you can slide the square around.
Remote control
Setting the camera up? Setup mode shoots every 10 seconds for 5 minutes so you can check framing and brightness quickly on this page. It ends by itself and goes back to the normal 3-minute interval — press it again to extend.
Torch is not available on this camera phone — the web torch API needs iOS 17.5+ or Android.
The camera phone takes the photo the moment something moves, instead of waiting for the next 3-minute shot.
Dark photos are auto-enhanced on the server: boosted, denoised and rendered in night-vision green (16 shades = the fastest transfer tier). Auto decides per photo by its brightness. Total darkness still shows black — a small night light works wonders.
16 colors reaches the watch about twice as fast. 32 costs the same to send and looks smoother. This page always shows full quality.
Changes reach the camera within about 10-30 seconds, and a fresh photo is taken right away. For rapid framing checks, use Setup mode — it is the only control that changes the shooting interval.
No camera found for this watch. Start the camera on the Cam page first — or, if you are a Crew member, ask your Leader to turn on camera sharing.